Selecting The Picture And Sound - Sony PCS-6000 Operating Instructions Manual

Selecting the Picture and Sound

To switch the picture
To switch the sound
You can select the picture and sound from both the local and remote sites
equipment.
To switch the picture displayed on the monitor from the local
or remote picture
Press the FAR/NEAR button on the Remote Commander, then switch the
picture by selecting the icons on the monitor screen with the joystick on
the Remote Commander.
To switch the video that will be sent to the remote sites
Press the VIDEO INPUT SELECT button on the Remote Commander to
switch the picture on the screen.
Main: The Camera Unit is selected.
Object: The equipment connected to the VIDEO IN OBJECT jack is
selected.
AUX1: The equipment connected to the VIDEO IN AUX 1 jack is
selected.
AUX2: The equipment connected to the VIDEO IN AUX 2 jack is
selected.
To switch the video sent from the remote terminal
Press the VIDEO INPUT SELECT button on the Remote Commander,
then select Main/Object/AUX1/AUX2 from Far.
Note
You cannot control the remote camera during a meeting if H.281 is not
selected as the far end camera control protocol.
Set Input Select in the Audio Setup menu as follows:
MIC: The microphone is selected.
AUX: When you input voice from external equipment connected to
AUDIO IN AUX.
MIC + AUX: When you input voice from external equipment connected
to both AUDIO IN AUX and MIC.
For details on the Input Select item, see "Audio Setup menu" on page 39.
Note
The audio input of the remote cannot be switched from the local system.
Chapter 2 Basic Operation During a Meeting
77