Troubleshooting - Honeywell TH8321 Product Data
Smart thermostat
Hide thumbs
Also See for TH8321:
- User manual (132 pages) ,
- Owner's manual (41 pages) ,
- Product data (40 pages)
Table of Contents
Advertisement
VISIONPRO® 8000 SMART THERMOSTAT
TROUBLESHOOTING
Symptom
Screen is blank
• Check circuit breaker and reset if necessary.
• Make sure power switch at heating and cooling system is on.
• Make sure furnace door is closed securely.
Screen is
• Change screen brightness using Preferences menu.
difficult to read
Red light is on
• If thermostat is in Emergency Heat mode, the red light is normal. It shows that the thermostat is in
Emergency Heat mode.
• If thermostat is not in Emergency Heat mode, an alert is active. Check message on the thermostat
screen.
Heating or
• Touch SYSTEM to set system to Heat. Make sure the temperature is set higher than the Inside
cooling system
temperature.
does not
• Touch SYSTEM to set system to Cool. Make sure the temperature is set lower than the Inside
respond
temperature.
• Check circuit breaker and reset if necessary.
• Make sure power switch at heating & cooling system is on.
• Make sure furnace door is closed securely.
• If "Wait" is displayed, the compressor protection timer is on. Wait 5 minutes for the system to restart
safely, without damaging the compressor.
33-00096—04
Table 10. Troubleshooting.
Action
90
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the TH8321 and is the answer not in the manual?
Questions and answers
I have a honeywell TH8321 R 1001 thermostate. I need to put more humidity in the house but I can not accomplish that.l The wondow protection is set at 10 which turns the himidity off in the house. my question is how do I turn the window protection off or adjust it so I can put more himidity in the house. Currently the himidty is 32%. Thanks for your help
To turn off or adjust the Window Protection setting on a Honeywell TH8321 thermostat to increase humidity in your house:
1. Ensure the thermostat is connected to an outdoor wired sensor or the Internet (Window Protection is only available with these connections).
2. Access the thermostat menu.
3. Locate the Window Protection setting.
4. Set Window Protection to "Off" to allow the humidifier to run up to the desired humidity setting without restriction.
5. If you prefer to adjust rather than turn it off, lower the Window Protection setting step by step and check for frost or condensation on windows each morning.
6. Continue adjusting to a lower number until no frost or condensation is present.
This will allow higher humidity levels in your home while preventing excessive condensation on windows.
This answer is automatically generated