106 Parameters
No.
Name/Value
DI1
DI2
DI3
DI4
DI5
DI6
DIO1
DIO2
Other [bit]
20.23
Positive speed
reference enable
20.23 Positive speed
reference enable
20.24 Negative speed
reference enable
23.01 Speed ref ramp in
01.01 Motor speed used
Off
On
DI1
DI2
DI3
DI4
DI5
DI6
Description
Digital input DI1
(10.02 DI delayed
Digital input DI2
(10.02 DI delayed
Digital input DI3
(10.02 DI delayed
Digital input DI4
(10.02 DI delayed
Digital input DI5
(10.02 DI delayed
Digital input DI6
(10.02 DI delayed
Digital input/output DIO1
Digital input/output DIO2
Source selection (see
Terms and abbreviations
Selects the source of the positive speed enable command.
1 = Positive speed enabled.
0 = Positive speed interpreted as zero speed reference. In the
figure below,
23.01 Speed ref ramp in
positive speed enable signal has cleared.
Actions in different control modes:
Speed control: Speed reference is set to zero and the motor is
stopped along the currently active deceleration ramp. The
rush controller prevents additional torque terms from running
the motor in the positive direction.
Torque control: The rush controller monitors the rotation
direction of the motor.
Example: The motor is rotating in the forward direction. To
stop the motor, the positive speed enable signal is
deactivated by a hardware limit switch (e.g. via digital input).
If the positive speed enable signal remains deactivated and
the negative speed enable signal is active, only reverse
rotation of the motor is allowed.
0.
1.
Digital input DI1
(10.02 DI delayed
Digital input DI2
(10.02 DI delayed
Digital input DI3
(10.02 DI delayed
Digital input DI4
(10.02 DI delayed
Digital input DI5
(10.02 DI delayed
Digital input DI6
(10.02 DI delayed
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
(11.02 DIO delayed
status, bit 0).
(11.02 DIO delayed
status, bit 1).
on page 73).
is set to zero after the
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
Def/FbEq16
2
3
4
5
6
7
10
11
-
On
0
1
2
3
4
5
6
7
Need help?
Do you have a question about the ACS880 and is the answer not in the manual?
Questions and answers