Sanyo DP26670 Service Manual page 22

Loading Motor PCB Ass'y
(2)
Lumirror Washer
Roller Cone
Shaft Roller
Frame Main Ass'y
(1)
(1)
• Screw Torque: 3.0 ± 0.3kgf•cm (Screw (1))
• Screw Torque: 0.8 ± 0.3kgf•cm (Screw (2)) • Screw Torque: 0.8 ± 0.3kgf•cm (Screw (2))
• Screw Torque: 1.0 ± 0.3kgf•cm (Screw (3))
NOTE
1. In case of the Gear Worm installation, check if the value
of the Fig. 2-3-C is correct.
2. When installing the wire of the Loading Motor PCB Ass'y,
install it correctly as Fig. 2-3-D.
Manual soldering conditions
• Soldering temperature: 350 ± 5
• Soldering time: Within 4 seconds
• Soldering combination: Sn-3.0Ag-0.5Cu
3. In case of the Roller Cone installation, install correctly as
Fig. 2-3-E.
4. In case of the Lumirror Washer installation,
install correctly as Fig. 2-3-F.
5. In case of the Gear Roller installation, check if the value
of the Fig. 2-3-G is correct.
6. After the assembly of the Loader Sub Ass'y, hook the wire
on the Loader Sub Ass'y as shown Fig. 2-3-H.
Gear Worm
Loading Motor
Safety surface for pressing of the insert.
DISASSEMBLY INSTRUCTIONS
Rack Lever
Loading Motor
Gear Worm
(3)
Chassis Main Ass'y
Lumirror Washer
Roller Cone
Gear Roller
(1)
Fig. 2-3-B
o
C
14.3 + 0, - 0.1mm
Fig. 2-3-C
Loading Motor PCB Ass'y
• Install wire from (1) to (2) in order.
RED(2)
BLACK(1)
Roller Sub Ass'y
(OK)
Safety surface for
pressing of the insert.
Roller Sub Ass'y
Loader Sub Ass'y
Check Hook
B2-3 B2-3
Fig. 2-3-D
(NG)
Fig. 2-3-E
Roller Sub Ass'y
(OK) (NG)
Fig. 2-3-F
1.8 + 0, - 0.1mm
Fig. 2-3-G
Check Hook
Fig. 2-3-H