Removal Of Dvd Deck Parts - Sanyo DP26670 Service Manual

2. REMOVAL OF DVD DECK PARTS

NOTE
1. Disassemble only the DVD DECK PARTS parts listed
here. Minute adjustments are needed if the
disassembly is done. If the repair is needed except
listed parts, replace the DVD MECHA ASS'Y.
2-1: TRAVERSE ASS'Y/LOADING MOTOR PCB ASS'Y/
PLATE TRVS UD (Refer to Fig. 2-1-A)
1. Remove the screw (1).
2. Remove the screw (2).
3. Unlock the 5 supports (3).
4. Remove the Insulator (R) from the Loader Ass'y.
5. Remove the Traverse Ass'y and Plate Trvs Ud.
Traverse Ass'y
Plate TRVS UD
(3)
Loader Sub Ass'y
• Screw Torque: 1.0 ± 0.3kgf•cm (screw(1))
• Screw Torque: 3.0 ± 0.3kgf•cm (screw(2))
NOTE
1. In case of the Traverse Ass'y installation, hook the wire
on the Loader Ass'y as shown Fig. 2-1-B to Fig. 2-1-C.
Loader Ass'y (Top side)
Check Lock
DISASSEMBLY INSTRUCTIONS
(1)
Insulator (R)
(2)
( ) (3)
(3) (3)
(3)
Fig. 2-1-A
Check Lock
Check Lock
Fig. 2-1-B
Check Lock
2.2: INSULATOR (R)/FEED RACK ASS'Y/
PCB630/GEAR MIDDLE/GEAR FEED/
FEED MOTOR/GEAR MOTOR
(Refer to Fig. 2-2-A)
1. Remove the Insulator (R).
2. Remove the screw (1).
3. Remove the Feed Rack Ass'y.
4. Unlock the 2 supports (2).
5. Remove the PCB630.
6. Remove the screw (3).
7. Remove the Gear Feed.
8. Remove the Gear Middle.
9. 9. Remove the 2 screws (4). Remove the 2 screws (4).
10. Remove the Gear Motor.
11. Remove the Feed Motor.
Gear Middle
(3)
Gear Feed
(2)
PCB630
• Screw Torque: 1.3 ± 0.3kgf•cm (Screw (1))
• Screw Torque: 2.5 ± 0.3kgf•cm (Screw (3))
• Screw Torque: 1.0 ± 0.3kgf•cm (Screw (4))
B2-1 B2-1
Fig. 2-1-C
Gear Motor
(1)
(4)
Feed Rack Ass'y
Insulator (R)
Chassis
Feed Motor
Fig. 2-2-A