TABLE OF CONTENTS INTRODUCTION ................2 SECTION 1 1.1 Important .................2 1.2 Explicit defi nitions ..............2 1.3 Functions ..................3 1.4 Included in your package ............4 CONTROLS AND PANEL ..............5 SECTION 2 Controls and panel description ..........5 INSTALLATION ................8 SECTION 3 3.1 Where and how to mount your mobile CB radio ....8 3.2 Antenna installation ...............9 3.3 Power connection ..............10 3.4 Basic operations before using your set for the fi...
Your Radio features a super heterodyne circuit with PHASE LOCKED LOOP techniques to assure precise frequency control. This document is the operating guide for the CB Transceiver LEGEND II Plus. 1.1 Important READ ALL INSTRUCTIONS carefully and completely before using the transceiver.
INTRODUCTION 1.4 Included in your package Supplied Accessories 1. LEGEND II PLUS 2. Microphone 3. Hook 4. Mounting bracket (with screws) 5. Knobs If any of these items are missing or damaged, immediately contact your place of purchase. NOTE You must use a CB antenna (sold separately) with this radio.
CONTROLS AND PANEL Controls and panel description Main Device *These drawings are just for reference, and do not reflect the final product. Front S/RF H-Cut RF GAIN AUTOMATIC ANL Back...
Page 8
CONTROLS AND PANEL ❶ AM/FM SELECT SWITCH ❿ SQUELCH KNOB Adjusts the level of the squelch Switch modulation mode to AM or FM. manually or turns to automatic control squelch mode (ASQ). ❷ FUNCTION SETTING MODE ⓫ RF GAIN KNOB SWITCH Switch function setting mode Adjusts the level of the signal ON or OFF.
Page 9
CONTROLS AND PANEL Microphone *These drawings are just for reference, and do not reflect the final product. ⓰ CHANNEL DOWN BUTTON ⓲ CHANNEL UP BUTTON Select channel down by press Select channel up by press or or long press for fast down. long press for fast up.
INSTALLATION 3.1 Where and how to mount your mobile CB radio BLACK Power supply (DC.12.8V) Antenna connector (SO-239) Jack for external loudspeaker (8Ω,∅3.5mm) ① You should choose the most appropriate setting from a simple and practical point of view. ② Your CB radio should not interfere with the driver or the passengers. ③...
INSTALLATION 3.2 Antenna installation Choosing your antenna • For CB radios, the longer and matched antenna is the better results. Mobile antenna • Must be fixed to the vehicle where there is a maximum of metallic surface (ground plane), away from windscreen mountings. •...
3.3 Power connection Your LEGEND II PLUS is protected against an inversion of polarities. Your equipment must be supplied with a continued current of 12 volts ① Check that the battery is of 12 volts.
INSTALLATION 3.4 Basic operations before using your set for the first time * Without transmitting and without using the switch on the [PTT] microphone ① Connect this microphone. ② Check the antenna connections. ③ Turn the volume knob clockwise to power ON the device. ④...
BASIC OPERATION 4.1 Power ON/OFF Turn the volume knob clockwise until the Power ON display comes on to on the radio. Turn the volume knob counterclockwise Power OFF until the display off to off the radio. 4.2 Volume control Increase the volume Turn the volume knob clockwise to increase the volume.
BASIC OPERATION 4.4 S/RF meter S/RF meter indicates the receiving signal strength in RX mode, and it is used as RF power indicator in TX mode. S/RF meter indicators have 4 steps from 1 (weak) to 4 (strong). 4.5 Channel select ➥...
OTHER FUNCTIONS 4.9 Dual channel watch select ① Select the sub channel to monitor or communication. ② Switch DW mode select switch to ON, the channel display will flashing. ③ Change the channel to be sub channel during the channel display flashing. ④ Press or wait 5 sec.
OTHER FUNCTIONS 5.2 Key beep ① Press key in , then [PTT] CONFIGURATION SET MODE KEY BEEP SET MODE displayed. ② Turn the channel selector on the device or push keys on the [UP] [DN] microphone to select “b1” (beep on) or “b0”(beep off). ③...
SPECIFICATIONS LEGEND II PLUS General Channels Modulation FM/AM Frequency Range 26.965 - 27.405 MHz Frequency Tolerance +/-200Hz Input Voltage 13.2V DC Dimensions 125(L) x 38(H) x 126.5(D) mm Weight Approx. 0.6 kg Antenna Impedance 50Ω Transmitter Maximum Output Power Transmission Interference <4nW...
GLOSSARY 7.1 Technical vocabulary Amplitude Modulation Citizen's Band Channel Continuous Wave Long Distance Liaison Dual Watch Frequency Modulation Greenwich Meantime High Frequency Low Frequency Lower Side Band Receiver Single Side Band Standing Wave Ratio Short Wave Listening Short Wave Transmitter Ultra High Frequency Upper Side Band Very High Frequency...
FREQUENCY LISTS 8.1 Frequency list (EU configuration) EUROPE 40 CH FM (4W), 40 CH AM (1W) CH № Frequency (MHz) AM RX AM TX FM RX FM TX ⃝ ⃝ 4W ⃝ ⃝ 1W 26.965 ⃝ ⃝ 4W ⃝ ⃝ 1W 26.975 ⃝...
FREQUENCY LISTS 8.2 Frequency list (PL configuration) POLAND -5KHz 40 CH FM (4W), -5KHz 40 CH AM (4W) CH № Frequency (MHz) AM RX AM TX FM RX FM TX ⃝ ⃝ 4W ⃝ ⃝ 4W 26.960 ⃝ ⃝ 4W ⃝...
FREQUENCY LISTS 8.3 Frequency list (D configuration) GERMANY 80 CH FM (4W), 40 CH AM (4W) CH № Frequency (MHz) AM RX AM TX FM RX FM TX ⃝ ⃝ 4W ⃝ ⃝ 4W 26.965 ⃝ ⃝ 4W ⃝ ⃝ 4W 26.975 ⃝...
Page 23
FREQUENCY LISTS GERMANY 80 CH FM (4W), 40 CH AM (4W) CH № Frequency (MHz) AM RX AM TX FM RX FM TX ✕ ✕ ⃝ ⃝ 4W 26.565 ✕ ✕ ⃝ ⃝ 4W 26.575 ✕ ✕ ⃝ ⃝ 4W 26.585 ✕...
FREQUENCY LISTS 8.4 Frequency list (EC configuration) CEPT 40 CH FM (4W) CH № Frequency (MHz) AM RX AM TX FM RX FM TX ✕ ✕ ⃝ ⃝ 4W 26.965 ✕ ✕ ⃝ ⃝ 4W 26.975 ✕ ✕ ⃝ ⃝ 4W 26.985 ✕...
FREQUENCY LISTS 8.5 Frequency list (UK configuration) CEPT FREQUENCY MODE EC 40 CH FM (4W) CH № Frequency (MHz) AM RX AM TX FM RX FM TX ✕ ✕ ⃝ ⃝ 4W 26.965 ✕ ✕ ⃝ ⃝ 4W 26.975 ✕ ✕...
Page 26
FREQUENCY LISTS ENGLAND FREQUENCY MODE EN 40 CH FM (4W) CH № Frequency (MHz) AM RX AM TX FM RX FM TX ✕ ✕ ⃝ ⃝ 4W 27.60125 ✕ ✕ ⃝ ⃝ 4W 27.61125 ✕ ✕ ⃝ ⃝ 4W 27.62125 ✕...
DECLARATION OF CONFORMITY I here by declare that the product LEGEND II PLUS, CB Radio satisfies all the technical regulations applicable to the product within the scope of Radio Equipment Directive (CE-RED) 2014/53/EU: ETSI EN 301 489-13 V1.2.1 (2002-08), ETSI EN 301 489-1 V2.1.1 (2017-02) ETSI EN 300 433 V2.1.1 (2016-05)
Page 28
M-Tech Dynamic Corporation Limited Unit 5, 17/F, Grandtech Centre, 8 On Ping Street, Shatin, New Territories, Hong Kong This user manual is subject to change according to M-Tech Dynamic Corporation Limited without notice. Printed in China...
Need help?
Do you have a question about the LEGEND II PLUS and is the answer not in the manual?
Questions and answers