Wincc Professional; System Requirements - Siemens SITOP Series Function Manual
Firmware v1.4: faceplates and communication blocks v2.4 for simatic step 7 v14 sp1, v15 and v15.1 tia
Hide thumbs
Also See for SITOP Series:
- Equipment manual (116 pages) ,
- Operating instructions manual (70 pages) ,
- Operating instructions manual (58 pages)
Table of Contents
Advertisement
7.4
WinCC Professional
7.4.1
System requirements
Prerequisites
You have created your TIA Portal project and the hardware and network configurations are
completed.
● Hardware configuration
– SITOP power supply (including the expansion modules)
– Controller
– HMI operator panel (Comfort Panel or Runtime Advanced)
● Network configuration
– PROFINET connection between controller and SITOP power supply
– HMI connection between controller and operator panel
You have integrated the SIMATIC STEP 7 blocks into your control project. (See chapter
Integrating the library blocks into SIMATIC STEP 7 (Page 101))
SITOP PSU8600 Firmware V1.4: Faceplates and Communication Blocks V2.4 for SIMATIC STEP 7 V14 SP1, V15 and V15.1 (TIA)
Function Manual, 11.2018, A5E37763954-09-76
Working with the library
7.4 WinCC Professional
127
- Quick Links:
- Hardware and Software Requirements
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SITOP Series and is the answer not in the manual?
Questions and answers