Bridge
Configuration
Listen Before
Transmit (LBT)
Settings
MDS 05-4846A01, Rev. D
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8461-MDS-UP-SD9-MS2ES-Upgrade-Key-SD9-MS-to-SD9-ES.aspx
Features
•
—Used to enable or disable Ethernet Bridging on the
Bridge Mode
radio. Default setting is
•
Basic Bridge Filter Sel
Available selections are:
and
.
Unicast Only
•
Adv Bridge Filter Status
traffic received from a specific Ethernet-enabled device matching
one of the Adv Src Addr Filter Values (see below).
•
Adv Src Addr Filter Val
Values. Four address values are available. If the Adv Bridge Filter
Status is on, and an incoming Ethernet frame src addr matches
any of these values, the radio bridges the frame. Otherwise, it is
dropped by the radio. The entry format must be
•
Listen Before Transmit
collision avoidance scheme called Listen Before Transmit (LBT).
It employs P-Persistent CSMA protocol, which senses channel
usage and inhibits transmission if the channel is currently in use.
CSMA is an abbreviation for Carrier Sense Multiple Access.
SD Series Technical Manual
.
OFF
—Sets the type of bridge filter to be used.
Broadcast/Unicast (All), Unicast and ARP,
—When on, this filter bridges the Ethernet
—Sets the Advanced SRC Address Filter
—The SD Transceiver provides an optional
.
xx:xx:xx:xx:xx:xx
47