Charging The Battery; Battery Use Cycle - Vatech EzRay Air VEX-P300 User Manual

Charging the Battery

Connect the battery charger to the battery charger connector as shown in the
1.
following figure.
When the battery charger is connected, the battery charging LED indicator light
2.
comes on. Charge the battery until all the three LED indicators are filled up.
Usually, it takes about 3 hours to fully charge the battery after a
complete discharge.
When the battery charge is completed, remove the battery charger from the
3.
device.
It is not able to perform an exposure while the battery charger is
connected to the device.

Battery Use Cycle

The battery is a consumable part. It is expected to degrade gradually, so it should be
recharged more frequently. When the battery duration decreases to half or less than
half compared to when the battery was new, contact your Service Representative to
get a new battery.
To check how to replace the battery, see 'Battery Replacement' on page 40.
EzRay Air (Model: VEX-P300) User Manual
4. Operation
39