Overheating Protection - Miele KM 7678 FR Operating And Installation

Overheating protection

All the induction coils and cooling ele-
ments for the electronics are fitted with
an overheating protection mechanism.
Before the induction coils and/or cool-
ing elements get too hot, the overheat-
ing protection mechanism cuts in in one
of the following ways:
Induction coils
– Any Booster function in operation will
be switched off.
– The set power level will be reduced.
– The heat for a zone switches off
automatically.  flashes alternately
with  in the timer display.
You can use the zone again as usual
when the fault code has gone out.
Cooling elements
– Any Booster function in operation will
be switched off.
– The set power level will be reduced.
– The heat switches off automatically.
The affected zones can only be used
again as usual once the cooling ele-
ment has cooled down to a safe level.
The overheating protection may be ac-
tivated under the following circum-
stances:
– The pans being used are empty.
– Fat or oil is being heated on a high
power level.
– Insufficient ventilation to the under-
side of the hob.
– A hot zone being switched on after
an interruption to the power supply.
If, despite removing the cause, the
overheating protection mechanism trig-
gers again, contact Miele Service.
Safety features
39