Phantom v2512 Manual page 17

STEP 2: INSTALL DE VICE DRIVER
Once the network card or converter is connected, the next step is to install the latest
device driver from the manufacturer's website. The camera should be powered on and
connected during the driver installation. After the driver is installed, reboot the PC.
A new, unidentified camera network should now be available in the Windows 'Network and
Sharing Center.'
STEP 3: INSTALL PCC WITH 10 Gb PHANTOM DRIVER
The latest version of PCC software should now be installed from the disk that came with
the camera or by running the setup.exe file within the package downloaded (and extracted)
from www.phantom-service.force.com
Click through the prompts, and be careful to click 'YES' when the program prompts you to
install the 10 Gigabit Ethernet Driver.
STEP 4: A SSIGNING A 10 Gb CAMER A NE T WORK
Just like assigning the 100.100 IP range for standard Gb Ethernet, the Phantom 10Gb
Ethernet network needs to be assigned to work in the 172.16 IP range. The camera should
be powered on and physically connected to the 10Gb network card or Thunderbolt adapter.
In the Windows 'Network and Sharing Center,' select the camera network. This opens
1.
the 'Ethernet Status' window.
2. Change the Ethernet IP settings by selecting 'Properties,' then 'TCP/IPv4' 'Properties,'
then select 'Use the following IP address.'
3. Enter:
• IP address: 172.16.0.1
• Subnet mask: 255.255.0.0
All other settings should be empty.
Click 'OK.'
4. Ensure the Windows Firewall is disabled for this connection.
Chapter 3: Net work Setup & Quick Star t Guides | 9