LuxaFlex 2106/56 Manual

FaceFix installation to a window frame / wall [F1]
Do not damage the product when using a sharp knife to open
the packaging! Fitting screws: Use a size-2 screwdriver (PO-
ZIDRIVE) or use an electric screwdriver at it's lowest torque.
FaceFix installation
1
Fitting the lower covers
2
Tensioning/slackening the steel wire
3
Push rmly to the right left to tension slacken
the steel wire
Subject to technical changes
use the original screws enclosed, to prevent malfunctioning
from using too thick screw heads!

Product width

116 - 150 cm
151 - 185 cm
186 - 220 cm
221 - 230 cm

Installation sequence

4 Note: if necessary, before clicking the rail
into place, slacken the steel wire
A
B
Connection
5
The built-in motor (24 V DC) with automatic end position
adjustment may only be connected to the 230V mains
using a stabilized 24 Volt DC Power Supply.
Only use Power Supplies and controls recommended
by the manufacturer of the Pleated Blind, to prevent
damage or malfunctioning caused by non-compatible
electric components! When connecting electric compo-
nents, the wiring diagram provided by the manufacturer of
the Power Supply must be observed.

Number of parts

0 - 80 cm 2 3
81 - 115 cm 3 4
3 5
4 6
4 7
5 8
x
x
Rail installation sequence on Clips
4-A1
4-B1
Model
2106/56
3 3 1 10
4 4 1 14
5 5 1 16
6 6 1 20
7 7 1 22
8 8 1 26
x
max. 70 cm
X=5 cm
x
max. 70 cm
4-A2
4-B2
Removal
C
B
A
Installation and User manual:
[F1]
3
4
5
6
7
8
83