LuxaFlex Roller blinds series Assembly And Operating Instructions

Assembly and operating instructions for
Skylight products
www.Luxaflex.com

General information

The basic assembly instructions given in this booklet apply to all skylight products: roller blinds, Venetian
blinds, Plissé blinds, Duette® Shades and combined products (roller blinds with Plissé or Duette® and
Plissé with Duette®). Details of the assembly procedure can vary from one product to another as described
below, however, it is important to read the information carefully before installing and using your skylight
product and to follow the assembly instructions carefully.

Contents of Package

The package you have received should contain the following items :
The Skylight product.
•
• 2 Cassette mounting brackets with 2 screws per bracket.
2 Side channels with 2 - 4 screws per channel depending on the drop of your blind.
•
• 2 Packing profiles with 3 screws per profile (only for use with 100 or 105° angle framed windows).
• 1 Side guiding sill bracket and cable locking ring (only supplied for wide Venetian blinds where a
centre support cable is required).
Please check that all the relevant components above have been supplied.

Standard Fitting Procedure

1. Preparation for fitting
Remove the skylight from its packaging.
Warning:
- Keep the product stacked at this stage.
- Do not remove transport cord cleat(s) or retaining tapes yet.
2. Fitting the cassette mounting bracket
Place the mounting brackets with the positioning
•
lip against the top of the frame, at least 100 mm
from the edges [1].
• Screw the brackets into place [2].
Now break off the positioning lips [3].
•
Skylight Products
GB
1 - 4