Chapter 14: Servo & Servo Rod Prepareration - Oxy Heli 5 Instruction Manual

-
You should now do some initial setup of your FBL unit and servos.
- We recommend you select a new model in your transmitter, and reset your FBL unit and start with a clean setup in it as well.
- After binding your transmitter to the receiver system used with the FBL unit, work your way through the FBL setup instructions to the point
you plug in your servos.
- Now set your collective stick in the middle position, and position the servo arms as close to the correct positions you can on each servo
see the following pages for arm orientations on the various servos.
- Next confirm the servos work in the correct direction, then return the collective stick to the center position.
- Now use your FBL unit to trim the servos so the arms are exactly horizontal (see pictures below).
- This procedure varies between units. Carefully label the position of the servos, then proceed with the installation of the servos as shown.
Linkage Ball Position
17.50( for Cyclic )
14.50 ( for Tail Servo )
Tail Servo
M2x6 Hex Cap Screw
Servo Arm
Servo Screw
page 37
Cylic Front Right Servo
Loctite 243
M2x6 Hex
Cap Screw
Servo Arm
Linkage Ball
Servo Rod Assembly ( 3pcs)
Plastic
Linkage Ball Linkage Ball
Cylic Front Left Servo
M2x6 Hex Cap Screw
Loctite 243
Servo Screw
M3x45 Turnbuckle Rod
Chapter 14: Servo & Servo Rod Prepareration
Cylic Rear Servo
Servo Arm
Linkage Ball
M2x6 Hex Cap Screw
Servo Screw Servo Arm
It is really important the servo rods screw onto
the linkages the same amount. The Metal Rod
have one side clock wire thread and one side
have counter clock wire thread
14mm
Clock Wire
20mm
Counter Clock Wire
Ref 30.50
Loctite 243
Servo Screw
Linkage Ball