Troubleshooting; Error Messages And Handling; Main Shaft Motor And Others; X, Y Motor-Related Errors - SWF SB Series User Manual

7

Troubleshooting

Error Messages and Handling

7.1.0

7.1.1 Main Shaft Motor and Others

No. Error Name
Main shaft motor stop position
100
error
101 Main shaft motor driver error
102 Main shaft motor overload error
103 No trimming system recovery
104 Start switch error
105 Stop switch error
107 Valve error
108 Air pressure error
109 Pulley ratio error
110 AC Line error
7.1.2

X, Y Motor-related Errors

No. Error Name
200 (+X) frame limit detection
201 (-X) frame limit detection
202 (+Y) frame limit detection
203 (-Y) frame limit detection
204 X-axis driver error
205 Y-axis driver error
206 Wiper return error
207 Trimmer return error
Error Description
When it is stopped, the main shaft's
angle is not 100˚
Main shaft motor driver develops an error.
When a thread tangles the hook, when
the needle bar's control body is bad,
and when the thread becomes tangled
during trimming, the error occurs.
When the trimming sensor is not
recovered upon trimming.
When the power is on, the start
button is pressed.
When the power is on, the stop
button is pressed.
When the valve is opened.
When the air pressure is below the
standard (Sequin)
When the set pulley ratio is wrong
When a problem occurs on the
joint board.
Error Description
The frame move system reaches
the +X limit.
The frame move system reaches
the -X limit.
The frame move system reaches
the +Y limit.
The frame move system reaches
the -Y limit.
Problems occur in the X-axis driver.
Problems occur in the Y-axis driver.
Wiper solenoid does not return.
Trimmer motor does not return.
7 7 - - 1 1
Handling
Use the lever to set the main shaft's
angle at 100˚
Turn off and on the main switch.
Check the hook of the front head,
and turn off and on the main switch.
Check and respond to the
abnormality of the trimming system.
Check whether the start button
contacts the connector.
Check whether the stop button
contacts the connector.
Change the driver setting after
checking the main shaft pulley ratio.
Replace the joint board
Handling
Move the frame in the -X direction.
Move the frame in the +X direction.
Move the frame in the -Y direction.
Move the frame in the +Y direction.
Turn off and on the main switch.
Turn off and on the main switch.
Repairs the wiper mechanism.
Repair the trimmer mechanism.