Neoface Access Control Registration - NEC EGW101 User Manual

Chapter 2 Installation and Connection

NeoFace Access Control Registration

Registering new NeoFace Access Control information.
Press the "System menu" button at the top right-hand side of the screen, and select "NeoFace Access Control" from the
menu displayed at the top of the screen.
From the menu displayed on the left side of the screen, select "NeoFace Access Control registration".
Input the NeoFace Access Control information.
Computer name
* Mandatory
NeoFace Access
Control name
* Mandatory
IP address
Area
* Mandatory
Master and slave settings - Master
Authentication mode *1
Authentication accuracy
Detection of mask
and sunglasses
*1 During initial setup of the card reader, if the "Card reader type" is set to unused, then the following authentication mode cannot
be used.
- Face and card linked authentication (walk-through)
- Face and card authentication
- Card authentication
82
Input contents
Computer name of terminal
Device name
Device IP address
Area 1 to area 20
- In the case of initial setting
In the event that you edited the
area name, select from the
edited area name
- Slave
Face and card authentication
(Walk through)
Face and card authentication
Face only authentication
(Walk through)
Face only authentication
Card authentication
- Strict
- Medium
- Loose
- ON
- OFF
NeoFace Access Control User's Guide
Description
Please enter the computer name set during the initial setup.
Please enter a unique name to distinguish between the terminals.
(Such 1F front gate 1)
Enter the IP address set with Initial setup,NeoFace Access
Control product.
* Note: Even if you change the IP address of this item, the IP
address of the computer terminal will not change. Device IP
address
Change must be done from the network setting of the main unit.
Select the area that has to be authenticated.
Note: If area is not selected, authentication will not be done.
Please select whether the relevant terminal is master or slave.
* Please select the one that matches the master and slave set
during the initial setup.
Person who uses brings the card in contact with NeoFace will be
authenticated with the face image photographed beforehand.
After the card comes into contact with NeoFace, the facial
image is captured and authenticated.
Authentication is performed as the person entering or exiting
come near the camera.
Authentication is performed when the person entering or exiting
touches the display screen.
Authentication is performed when the card touches NeoFace.
Authentication can be set to three levels of strict, medium, or
loose.
* If you select "Card authentication" in the authentication
mode, this item will not be valid.
When this feature is in the ON mode, on detecting a person
wearing masks or sunglasses, authentication can be set to failed.
* If you select "Card authentication" in the authentication mode,
this item will not be valid.
Setup
5.