Troubleshooting - KitchenAid 3KSMC895 Manual

CARE AND CLEANING
Planetary Cleaning Instructions
1� Unplug the Stand Mixer or disconnect the
power�
2� Remove the retaining ring with
retaining ring pliers� Slide the ring
and the washer down the shaft�

TROUBLESHOOTING

Please read the following before calling
your service centre�
1� The Stand Mixer may warm up during
use� Under heavy loads with extended
mixing time periods, you may not be
able to comfortably touch the top of
the Stand Mixer� This is normal�
2� The Stand Mixer may emit a pungent
odor, especially when new� This is
common with electric motors�
3� If the flat beater hits the bowl, stop
the Stand Mixer� See the "Beater to
Bowl Clearance" section�
©2018 All rights reserved� KITCHENAID and the design of
the stand mixer are trademarks in the U�S� and elsewhere�
Book 1.indb 15
3� Clean the shaft, retaining ring, and
4� To reassemble, reverse steps 1 through 3,
Flat Beater Cleaning Instructions
1�To clean the drain hole in the flat
beater, use a small round brush,
toothpick, or skewer to run through the
Retaining Ring
Groove hole�
Washer
Retaining Ring
If your Stand Mixer should malfunction or
fail to operate, please check the following:
- Is the Stand Mixer plugged in?
- Is the fuse in the circuit to the Stand
- Turn the Stand Mixer off for 10-15
washer with a mild detergent and wash
cloth� Do not use abrasive cleaners or
scouring pads� Do not immerse the Stand
Mixer in water�
making sure retaining ring is fully seated
into groove�
Mixer in working order? If you have a
circuit breaker box, be sure the circuit
is closed�
seconds, then turn it back on� If the
mixer still does not start, allow it to
cool for 30 minutes before turning it
back on�
TROUBLESHOOTING | 15
5/30/2018 8:44:13 PM