Entering Channel System Data - GE DigitalFlow GS868 Programming Manual

March 2008
Entering Channel System
Data
1-10
•
To continue programming the meter, refer to the menu maps in
Appendix A and navigate to the desired menu. Then, proceed to
the appropriate section of this manual for instructions.
•
To leave the User Program and retain the previous settings,
[EXIT]
press twice and then press
Any programming changes will be discarded and you will be
returned to the data display.
•
To leave the User Program and return to measurement mode,
[EXIT]
press twice and then press
Your programming changes will be entered into the meter's
memory, and you will be returned to the data display.
Note: See the
SAVE
submenu section on page 1-49 of this chapter for
more information on this function.
While following the programming instructions, refer to the menu map
in Figure A-1 on page A-1.
IMPORTANT:
Do not confuse this
enter channel-specific information, with the
submenu of the
information applicable to both channels.
1. To enter the
SYSTM
submenu, press
prompt.
2. Enter a Channel Label of up to 9 characters. Press
3. Enter a Channel Message of up to 21 characters. Press
4. At the Equation prompt, press
data in standard volumetric units, or press
measurement data in actual volumetric units. The GS868 uses the
appropriate gas equation to calculate the flow rate in the
volumetric units indicated.
5. Use the
[F1]-[F4]
and [→] keys to select the desired Volumetric
Units for the flow rate display.
The abbreviations and definitions of all the available volumetric and
totalizer units are shown in Table 1-2 on page 1-11. The choices
shown on the option bar are determined by the selection made at the
SYSTEM UNITS
previous screen.
[F1] = NO
at the SAVE prompt.
[F2] = YES
at the Save prompt.
SYSTM
submenu, which is used to
GLOBL
menu, which is used to enter
[F2] Channel PROGRAM
at the
[ENT]
[F1]
to display the measurement
[F2]
to display the
Programming Site Data
SYSTM
.
[ENT]
.