General Circuit Diagram; Signal Names - Canon Finisher-R1 General Timing Chart/General Circuit Diagram

2 General Circuit Diagram

Signal Names

List of Signal Names/Abbreviations (Finisher Unit)
The following presents the abbreviations of signals used in this manual and in drawings, and the meaning of each signal.
Reference: Signals enclosed by brackets [ ] are electrical signals, However, the state "1" or "0" of these analog signals cannot be indicated. Otherwise, the state of digital signals "1" or "0" can be indicated.
T-2-1
ASSIST-HP REAR END ASSIST GUIDE HP DETECT Signal
BIND-CL STACK EJECTION LOWER ROLLER CLUTCH DRIVE Signal
BUFF-P-SL BUFFER REAR END HOLDING SOLENOID DRIVE Signal
BUFF- BUFFER ROLLER ALIENATE SOLENOID DRIVE Signal
ROL-SL
DELIV- 1ST DELIVERY ROLLER ALIENATE SOLENOID DRIVE Signal
ROL-SL
F-COVER FRONTCOVER OPEN/CLOSE DETECT Signal
F-COVER- FRONT DOOR CLOSED DETECT SWITCH Signal
SW
FJOG-HP FRONT ALIGNMNT PLATE HP DETECT Signai
G- GEAR CHANGE HP DETECT Signal
CHANGE-
HP
INLET INLET PAPER DETECT Signal
INLET- INLET ROLLER ALIENATE SOLENOID DRIVE Signal
ROL-SL
JOGTRY-P PROCESSING TRAY PAPER DETECT Signal
RJOG-HP REAR ALIGNMNT PLATE HP DETECT Signal
SHUT-CL SHUYYER OPEN/CLOSE CLUTCH DRIVE Signal
SHUT-HP SHUTTER HP DETECT Signal
STP-HP STAPLER HP DETECT Signai
STP- STAPLER ALIGNMENT INTERFERENCE DETECT Signal
INFERE
STP-LS HOOK EMPTY DETECT Signai
STP- HOOK TOP POSITION DETECT Signai
READY
STPSFT- STAPLER SHIFT HP DETECT Signal
HP
STP-SW CARTRIDGE DETECT SWITCH Signal
SWG-HP SWING GUIDE HP DETECT Signai
SWG-SW SWING GUIDE OPEN DETECT SWITCH Signal
3