Entering Daytime Limits; Custom Names; Custom Zone Names - Visonic PowerMaster-360R Installer's Manual

4.7.3 Entering Daytime Limits

  
05:OUTPUS
Enter the "LOCKOUT TIME" menu and enter the daytime limits through which the PGM device will turn off, even when
the associated sensors are triggered.
Step 1
Select "05:OUTPUTS"
menu

05:OUTPUTS
Step 5
Press

start- HH:MM

4.8 Custom names

4.8.1 Custom zone names

During the device enrollment process you also define the Location name where the device is installed. The location
name is selected from a Location List of Custom names - see Section 4.4.2, Part B, for Location List and instructions.
Define the custom location names according to your specific needs and use them during device enrollment.
To define the Custom Location names, follow the instructions below. Additional guidance is provided in section 4.2.
06:CUSTOM NAMES
Enter CUST.ZONES NAME (see guidance above), then refer to the table below which provides you with detailed
explanations and programming instructions to edit the desired custom location.
Note: All 31 location names can be edited..
Configuration instructions
Enter the Custom Location names you wish to edit.
To edit:
Press to enter the CUST. ZONES NAME sub menu and then press
to edit, for example TEXT LOC. #01 – the display alternates with the current Custom name, for example, Master
Bdrm. To change the name, at the blinking cursor, enter the Location name you wish and at the end, press
confirm. When done, press
Note: To enter the Location name use the String Editor below.
IMPORTANT! The editing of a custom zone name automatically deletes the original text.
D-307083 PowerMaster-360R Installer's Guide
LOCKOUT TIME
Step 2
Select "LOCKOUT
TIME" menu

LOCKOUT TIME
Step 6
Press

stop- HH:MM
  
CUST.ZONES NAME
to return.
...
Step 3
Press

start- HH:MM
Step 7
Enter the time at which
you wish the lockout
state to end

TIME 19:00
4. Programming
Step 4
Enter the time at which
you wish the lockout state
to begin

TIME 11:30
Step 8
Press
to "LOCKOUT TIME" or
to take you to
"<OK> TO EXIT"

stop- HH:
again to select the Location # you wish
to return
to
47