Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for ELECTROCOMPANIET ECI 3
Summary of Contents for ELECTROCOMPANIET ECI 3
- Page 1 ECI 3...
-
Page 2: Setup Procedure
2 pcs batteries. Set up procedure Before connecting the ECI 3 to the mains, check that the mains voltage indicated on the rear panel corresponds to the line voltage in the territory were you intend to use the unit. How to avoid damages Do not under any circumstances connect or disconnect equipment when power is turned on. -
Page 3: Gain Switch
You should always power up your system the following way: Signal sources (CD Player, tuner etc.) first. Allow a 30 seconds warm-up before you turn on the ECI 3. When switching off your system: Start with the ECI 3, then the signal sources. -
Page 4: Remote Control
If the ECI 3 has been switched off, allow two hours of warm-up for optimal sonic performance. When the ECI 3 is not to be used for a long period of time, use the main switch to turn the unit off. -
Page 5: Replacing A Blown Mains Fuse
Replacing a blown mains fuse Diagram 4 The mains fuse is located in a small drawer inside the AC inlet of the unit. If, for some reason the fuse is blown, turn the unit off, and remove the AC cord from the AC inlet. Open the drawer with a small screwdriver and remove the blown fuse. -
Page 6: Preamplifier Section
4 Ohm 2 x 120 W 2 Ohm 2 x 160 W Power consumption (no load or signal) 70 W The ECI 3 is DC coupled from input to output. Dimensions Width: 483 mm - 19 “ Depth: 410 mm - 16.1 ”... -
Page 7: Important Notice
For optimal sonic performance, the ECI 3 should be burned in for a minimum time of 72 hours. The easiest way to burn in your ECI 3 is to put a signal at any input, without the speakers connected In daily operation, switch off the ECI 3 by using the MUTE button on the remote control. - Page 10 www.electrocompaniet.no...
Need help?
Do you have a question about the ECI 3 and is the answer not in the manual?
Questions and answers