Installing The Wireless Repeater; Led Operation - DMP Electronics 1100R Installation Manual

Installing the Wireless Repeater

Mount the 1100R on a flat surface such as a wall or single-gang box near a wall outlet for the Model 376 plug-in
power supply. The 1100R Wireless Repeater is typically mounted in a location that will be located between the
1100 Series transmitters and the 1100 Series Receiver used in the installation. Install the repeater away from large
metal objects. Mounting the repeater on or near metal surfaces impairs performance. When selecting the proper
mounting location of a repeater, refer to the LED Survey Operation section.
Remove the cover from the plastic housing by squeezing both sides toward each other. Secure the repeater to the
wall in the desired location using the supplied screws in the mounting hole locations as shown in Figure 1. Snap the
cover back on the unit.
Squeeze to
Remove Cover

LED Operation

Five LEDs display repeater operation and activity. Refer to the table below as required.
LEDs
PWR Steady Green to indicate there is power to the repeater.
RX Flashes Yellow to indicate data is being received.
TX Flashes Green to indicate data is being sent.
BAD Steady Red to indicate the repeater cannot establish communication with the receiver.
GOOD Steady Green to indicate communication has been established with the receiver.
Digital Monitoring Products
2
Mounting Hole
Locations
Battery
Start
DC Power
J1
1
Supply
Barrel Jack
Figure 1: 1100R Repeater PCB Layout
Mounting Screw
LEDs
1
Operation
Tamper
J4
Switch
Squeeze to
Remove Cover
1100R Installation Guide