DMP Electronics 1100R Installation Manual

Description

The 1100R Wireless Repeater provides an increased communication range by forwarding messages from the transmitter to the
wireless receiver. Up to eight repeaters can be installed on a wireless system. The repeater is powered from a 12VDC power
supply and includes a 24-hour battery backup. The 1100R Wireless Repeater provides a built-in survey capability to allow for
single-person installations, eliminating the requirement for an external survey kit.

Compatibility

All DMP 1100 Series Wireless Receivers using
Version 106 or higher software

What is Included

• One Model 1100R Repeater
• One Lithium Polymer Rechargeable Battery
• Zone name and number label
• Serial number label
• Hardware pack
• One (optional) Model 376L Plug-In DC
Power Supply

Program the Panel

Program the repeater in the panel as a wireless
zone. Program the wireless House Code in
System Options prior to adding DMP wireless
zones to the system. Refer to the panel
programming guide as needed.
1. In ZONE INFORMATION, enter the
wireless ZONE NO:.
2. Enter the ZONE NAME.
3. Select AUX (auxiliary) as the ZONE TYPE.
4. Program ARMED OPEN and DISARMED OPEN as TROUBLE.
5. Program ARMED SHORT and DISARMED SHORT as ALARM.
6. Select YES when WIRELESS? displays.
7. At SERIAL NO:, enter the repeater's eight-digit serial number.
Note: If using multiple repeaters, they must be programmed as sequential zone numbers.
8. At SUPRVSN TIME, press CMD to accept the default time of 240 minutes. Press any select key to select the supervision
time required for the wireless repeater. When an 1100 series receiver is installed, powered up, or the panel is reset,
the supervision time for any repeaters and transmitters are reset.
9. Press the select key under the required number of minutes. A CHECKIN time of 60 or 240 minutes should be selected.
Note: The repeater must check in at least once during this time or a missing condition is indicated for that zone. Since
1100R repeaters automatically check in based on the supervision time selected for the wireless zone, no additional
programming is needed. Any programming prompts for contact or other information can be ignored.
1100R Wireless Repeater
Mounting Screw
Shoulder Washer
Battery
Start
DC Power
2-position
1
Terminal
Block
Insert small
screwdriver
and lift to
remove cover
INSTALLATION GUIDE
LEDs
Mounting Hole
Locations
J1
Figure 1: 1100R Repeater PCB Layout
Tamper
J4
1
Switch
Tamper Disable
Insert small
Header
screwdriver
and lift to
remove cover