Care And Maintenance - Erbauer ERH18-Li Original Instructions Manual

OVERLOAD, TEMPERATURE AND CHARGING PROBLEM
Problem Tool/ Battery Status Possible cause
Overload Product suddenly Extremely high
protection Stops; The LED torque, binding and
work light (if fitted) is stalling situations,
flashing overloading of the
tool
Temperature The first and the Battery temperature
extremely high third LED light of the exceeds 77°C
POWER BAR will be during operation
flashing alternately
Low charge Power for the tool will The battery pack is
drop quickly; The first under 5% charge
LED on the POWER
BAR begins to flash
Other Short charges Not fully charged
problems
Poor storage
condition
24
Solution
Relieve the load
immediately, reset the tool
by switching off and back
MAINTENANCE
on again
Your tool requires no additional lubrication or maintenance. There are no user serviceable
parts in your power tool. Never use water or chemical cleaners to clean your power tool.
Cool down the battery to
Wipe clean with a dry cloth. Always store your power tool in a dry place. Keep the motor
below 77°C for operation
ventilation slots clean. Keep all working controls free of dust.
and below 57°C for
RECYCLING AND DISPOSAL
charging
Remove the battery pack
from the tool and charge it
Make sure that the battery
DISPOSAL OF AN EXHAUSTED BATTERY PACK
is fully charged every time
by allowing the charger to
complete its full charging
cycle
Always remove battery
from the tool and charger
when not in use and
store in a dry secure
place. Avoid charging
REPAIR
or storing your battery
This product does not contain any parts that can be repaired by the consumer. Contact an
in temperatures below
authorised service centre or a similarly qualified person to have it checked and repaired.
5°C and above 40°C.
Cool down a hot battery
STORAGE
pack from a tool that has
•
just been operated for
•
approximately 30 minutes
•
before storage
•
•
TRANSPORTATION
•
•
•
•
•
CARE & MAINTENANCE
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or retailer
for recycling advice.
For further information visit www.recycle-more.co.uk
To preserve natural resources, please recycle or dispose of the battery pack
properly. This battery pack contains Li-Ion batteries. Consult your local waste
authority for information regarding available recycling and/or disposal options.
Discharge your battery pack by operating your tool, then remove the battery
pack from the tool housing and cover the battery pack connections with heavy-
duty adhesive tape to prevent short circuit and energy discharge. Do not
attempt to open or remove any of the components.
Switch the product off and remove the battery pack.
Clean the product as described above.
Store the product and its accessories in a dark, dry, frost-free, well- ventilated place.
Always store the product in a place that is inaccessible to children.
We recommend using the original package for storage or covering the product with a
suitable cloth or enclosure to protect it against dust.
Switch the product off and remove the battery pack.
Attach transportation guards, if applicable.
Always carry the product by its handle.
Protect the product from any heavy impact or strong vibrations which may occur during
transportation in vehicles.
Secure the product to prevent it from slipping or falling over.
25