Mesh Enabled Architecture
Installing the WMC6300 Wireless Modem Card
After installing the MEA software, MeshTray must be active when installing the WMC6300 card.
Connect the Antenna Assembly
Complete the following procedure to connect the Antenna Assembly (Knuckle or Pigtail type) to
the WMC6300 for use in a standard laptop computer.
Locate the Antenna and insert the connector into the WMC6300 antenna port as shown in
Figure
26.
NOTE: The connector will snap into place when fully inserted.
Figure 26.
Use of another antenna is prohibited and violates FCC regulations.
Never use the WMC6300 with the Antenna disconnected from the Card.
WMC6300 Windows Users Guide
ATTENTION
ATTENTION
Always eject card when not in use.
Attach the Antenna to the WMC6300
ATTENTION
Use only FCC approved antennas.
19