Advertisement
before plugging in
Make sure your electricity supply is
the same as the one shown on the
underside of your toaster.
This appliance conforms to EC
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
Important – UK only
The wires in the cord are coloured
as follows:
Green and Yellow = Earth,
Blue = Neutral,
Brown = Live.
The appliance must be protected by
a 13A approved (BS1362) fuse.
W RNING: THIS
MUST BE E RTHED.
Note:
For non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
If a non-rewireable plug is cut off it
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
before using for the first time
1 Wrap excess cord around the cord
storage device on the underside of
the toaster
Operate the toaster once on a
medium setting without bread. (The
lever will not stay down unless the
toaster is plugged in).
As with all new heating elements,
your toaster may emit a slight
burning smell when it is first
switched on. This is normal and not
a cause for concern.
PPLI NCE
.
Use the carriage lever to lift the
toast to Peek & View™ at any
time without cancelling the toasting
cycle.
key
warming rack selector
(TTP220 /TTP230)
warming rack (TTP220/TTP230)
Peek & View™ carriage lever
(with 'Hi-Rise™' for extra lift)
browning control
reheat button with indicator light
defrost button with indicator light
cancel button with indicator light
crumb tray
cord storage
to use your toaster
1 Plug the toaster into the power
supply.
2 Move the browning control to the
desired setting. Use a low setting
for light toasting and for thin or dry
bread.
3 Insert the bread, muffins, bagels etc.
4 Lower the lever
'cancel' button will illuminate. (The
lever will not stay down unless the
toaster is plugged in).
To toast frozen bread, once the
bread is lowered press the 'defrost'
button. The 'defrost' button will
illuminate.
To warm toast that's popped up but
gone cold, lower the toast then
press the 'reheat' button. The
'reheat' button will illuminate.
Use the carriage lever to lift the
toast to Peek & View™ at any
time without cancelling the toasting
cycle.
To stop toasting during the cycle,
press the 'cancel' button, the toast
will pop up and the 'cancel' button
light will go off.
5 Your toast will pop up
automatically, to raise it higher, lift
the lever.
4
until it locks. The
Advertisement
