CUMMINS ALLISON JetSort 1000 Series Set Up And Operating Instructions Manual page 4

All container totals are cleared when changing to package mode. Record container totals if
needed before proceeding.
1. Press and hold End key for 5–10 seconds or until the following screen appears:
Norm
Pkg only must be selected in setup for the Norm/Pkg screen to appear when End is held. If the
screen does not appear, return to setup and retrace the steps to select a packaging option.
2. Press Start S/Bat to select Pkg (until cursor appears under "P" as shown above).
3. Press Clear to return to a Batch Ended screen.
4. Remove the coin box/bag under all denomination(s) to be packaged.
5. If using packaging kit, insert now with the paper wrapper properly fitted inside the denomination tube.
•
If using preformed coin-packaging tubes, insert the paper wrapper into the plastic tube until there is some
resistance.
•
If using flat coin packaging wrappers, first shape the paper wrapper - then insert the wrapper halfway into
the plastic tube. This ensures that coins fall properly into the paper wrapper.
6. Pour coin into hopper. Press Start Batch to begin packaging.
There is a one- to two-second delay before the last coin drops into the wrapper. Do not remove
the wrapper until the sort disk rotates the final coin into the tube.
7. When limit is reached for the packaged denomination, replace coin tube. Press Clear.
1c
LIMIT
8. Press Clear again to continue processing coin (denomination may vary from illustration).
1c
CLEAR THIS ROLL?
4 | JetSort 1000 series | JetSort® 1000 Series Coin Packaging Instructions
®
Pkg
1c
50
0