European Community (Ec) Mark Of Conformity Statement; Electrostatic Discharge (Esd); Japanese Electrical Appliance And Material Safety Law Statement; Japanese Power Line Harmonics Compliance Statement - Toshiba 1NR Hardware Service Manual

European Community (EC) Mark of Conformity Statement

This product is in conformity with the protection requirements of EC Council
Directive 89/336/EEC on the approximation of the laws of the Member States
relating to electromagnetic compatibility. Toshiba Global Commerce Solutions
cannot accept responsibility for any failure to satisfy the protection requirements
resulting from a non-recommended modification of the product, including the fitting
of non-Toshiba Global Commerce Solutions option cards.
This product has been tested and found to comply with the limits for Class A
Information Technology Equipment according to CISPR 22 / European Standard EN
55022. The limits for Class A equipment were derived for commercial and industrial
environments to provide reasonable protection against interference with licensed
communication equipment.
Warning: This is a Class A product. In a domestic environment this product may
cause radio interference, in which case the user may be required to take adequate
measures.

Electrostatic Discharge (ESD)

Attention:
difference in charge between the part, the product, and the service person. No
damage will occur if the service person and the part being installed are at the same
charge level.
ESD damage prevention
Anytime a service action involves physical contact with logic cards, modules,
back-panel pins, or other ESD sensitive (ESDS) parts, the service person must be
connected to an ESD common ground point on the product through the ESD wrist
strap and cord.
The ESD ground clip can be attached to any frame ground, ground braid, green
wire ground, or the round ground prong on the AC power plug. Coax or connector
outside shells can also be used.
Handling removed cards
Logic cards removed from a product should be placed in ESD protective containers.
No other object should be allowed inside the ESD container with the logic card.
Attach tags or reports that must accompany the card to the outside of the container.

Japanese Electrical Appliance and Material Safety Law statement

Japanese power line harmonics compliance statement

Electrostatic discharge (ESD) damage can occur when there is a
81
Appendix B. Notices