Rohde & Schwarz FSW43 User Manual page 1027

®
R&S FSW
Parameters:
<ScalingType>
Manual operation:
[SENSe:]CORRection:TRANsducer:SELect <Name>
This command selects a transducer factor.
Parameters:
<Name>
Example:
Manual operation:
[SENSe:]CORRection:TRANsducer[:STATe] <State>
This command turns the selected transducer factor on or off.
Before you can use the command, you have to select a transducer.
Parameters:
<State>
Manual operation:
[SENSe:]CORRection:TRANsducer:UNIT <Unit>
This command selects the unit of the transducer factor.
Before you can use the command, you have to select and turn on a transducer.
Parameters:
<Unit>
Example:
Manual operation:
String
'DB'
'DBM'
'DBMV'
User Manual 1173.9411.02 ─ 19
LINear | LOGarithmic
*RST: LINear
See "X-Axis Scaling" on page 575
String containing the name of the transducer factor.
If the name does not exist yet, the R&S FSW creates a trans-
ducer factor by that name.
CORR:TRAN:SEL 'FACTOR1'
See "Activating/Deactivating"
See "Create New Line"
See "Name" on page 574
ON | OFF
*RST: OFF
See "Activating/Deactivating"
string as defined in table below
*RST: DB
CORR:TRAN:UNIT 'DBUV'
See "Unit" on page 575
Unit
dB
dBm
dBmV
Remote Commands
Configuring the R&S FSW
on page 573
on page 573
on page 573
1027