Maxair CAPR User Instructions page 95

17. Tuck Hood inner Shroud
under the outer body
gown and secure the
gown closure. Pull Hood
outer Shroud over the
shoulders and body.
Don HFR FCC (Optional, depending upon fluid resistance protection desired.)
1. Initiate donning the HFR FCC (High
Fluid Resistant Filter Cover Cap) by
placing it over the front of the Helmet
and down towards the back.
Doff HFR FCC (If it was Donned)
1. Hold HFR FCC front and lift
its rear up over Helmet.
Page 95 P/N 03521015 Rev Q
Don HLF (NOT optional - Required per NIOSH Approval)
1. Initiate donning the HLF
(Heavy Loading Filter) by
tucking its back bottom up
under back bottom of Helmet
2. Continue bringing the HFR
FCC down over the Helmet
so that it covers the HLF.
2. Remove HFR FCC com-
pletely and decon for next
use.
2. Complete by pulling HLF over
and down, rear-to-front, of the
Helmet and securing front bot-
tom on Hood front Velcro strip.
3. As needed, pull down back of HFR FCC with fingers in
back while pushing up on under side of Helmet back with
thumb.
Doff HLF
1. Begin HLF doffing by curling its back bottom up over Helmet
back bottom.
2. Either continue grasping the HLF and lift it up, over, and off the
Helmet and discard appropriately, or,
you may temporarily leave it on the Hood and proceed to Doff it
with the Hood (next section).
3. Ensure Hood outer Shroud is
fully down on all sides, secure
neck ties to within about 1/2
inch of neck, and feed body
ties through front Hood Shroud
slits and tie securely.
ALTERNATIVELY,