Set The Warning Buzzer On/Off; Change The Illumination Color; Offset Adjustment Of Turbo (2.0 And 1.2) And In-Mani Press - Defi -Link Advance Operation Manual

(Ex. You can NOT connect 2 turbo2.0 gauges together.)
5. Return the slide switch to

7 -6-2. Set the warning buzzer ON/OFF

By sliding the dip switch1 of the control unit, the warning buzzer sound is
turned ON/OFF. The switch operation sound cannot be canceled.
Please set while the ignition is off.
The setting of warning buzzer for ZD is controlled by ZD. Refer to ZD
manual.

7 -6-3. Change the illumination color

Illumination color for CR/RS gauges can be selected from 2 colors. Illumina-
tion color of BF/A1 and ZD can not be changed.
1. Set the slide switch to
2. If the
L
3. Select the gauge by pressing
4. When the
M
same time, the illumination color changes.
CR white dial: blue ⇔ amber red
CR black dial: white ⇔ amber red
RS black dial: classic green ⇔ classic white
In case that CR/RS gauges and ZDs are installed together and the dimmer set-
ting is AUTO, the illumination of CR/RS gauges turned ON/OFF automatically
regardless ON/OFF of the illumination switch of vehicle. If the setting is done
in bright light, the illumination of CR/RS gauges may be unlighted. Please
place a hand over the dim sensor of ZD or move vehicle to a dark place.
5. Return the slide switch to

7 -6-4. Offset adjustment of Turbo (2.0 and 1.2) and In-Mani Press

The needle pointer of turbo should indicate 0kPa when the ignition is on. But
or
U
.
L
button is pressed, the gauge shifts to Setup mode.
L
button and the
or
U
69
.
M
button.
button are pressed at the
R
.
M