Care And Cleaning - Whirlpool SKT60 Series Installation Instructions Manual

2. Align the top plate (D) holes with the holes in the appliances
and install the remaining three screws (L) as shown.
NOTE: Do not completely tighten the screws.
3. Push the refrigerator and freezer fully into the opening.
4. Check the level of the each appliance since it may have
changed when you moved it into the opening.
NOTE: Depending on the level of the floor, you may need to
remove each appliance and readjust several times to achieve
a satisfactory alignment.
5. Completely tighten all four screws (L) in top plate (D).
Install Bottom Grille Assembly
1. Align the four clips on the bottom grille assembly (H) (two for
each cabinet) with the edge of the rounded openings in the
base of the cabinets.
8
A
A. Grille clips aligned with edge of rounded openings
2. Push and snap all the grille clips into place.
NOTE: Make sure the grille clips are fully engaged and that
the base grille side caps are situated outside the hinge
bracket on each appliance.
Install the Gap Filler
1. Place the magnetic gap filler (F) between the refrigerator and
freezer to fill in the gap between the appliances.
NOTE: The gap filler (F) should be flush with the tops of the
appliance cabinets.

Care and Cleaning

Clean the trim and grille surfaces with a cotton cloth dampened
with a solution of mild dish detergent and warm water. Do not use
harsh or abrasive cleaners because they will damage the metal
surface of the grille and trim.
A