Installation Requirements; Plan The Installation; Opening Requirements; Tools Needed - Whirlpool SKT60 Series Installation Instructions Manual

The SKT60* Trim Kit provides an integrated appearance when
installing an all-refrigerator and upright freezer side by side.

Plan the Installation

Plan your installation using these instructions in conjunction with
the Use & Care Guides provided with the refrigerator and freezer.
IMPORTANT:
For ease in handling and alignment, it is required that 2 people
install the trim kit.
Make sure there is enough area, approximately 7 ft (2.1 m) by
10 ft (3.1 m) to assemble parts on the floor.
Lay a drop cloth on the floor to cushion the parts and cover
the flooring.
These instructions are intended as a general guide only and
do not supersede any national or local codes in any way.
Compliance with all local, state or national codes pertaining to
this type of installation should be determined prior to
installation.

Opening Requirements

Make sure the opening is 74¹⁄₂" (189.2 cm) high by 62¹⁄₈"
(157.8 cm) wide by 24¹⁄₄" (61.6 cm) deep, as shown.
The inner opening dimensions of the installed trim kit will be
61.31" (155.7 cm) wide by 66.85" (189.7 cm) high.
NOTE: It is possible to make the trim kit fit vertical openings that
are less than 74¹⁄₂" (189.2 cm) high. The trim kit can be reduced in
height by 1" (2.54 cm) increments. Each top grille (B) section is 1"
(2.54 cm) in height. For each top grille (B) section that is not used,
1" (2.54 cm) must be cut from the base of both the left-hand (E)
and right-hand (G) side trim pieces.
(67.3 cm)

Tools Needed

Assemble the required tools and parts before starting installation.
Read and follow the instructions provided with any of the required
tools listed here. Proper installation is your responsibility.
Tools Needed
Cordless drill, ¹⁄₈" bit
Phillips screwdriver
Flat-blade screwdriver
Socket drive #2 bits
†®TORX is a registered trademark of Saturn Fasteners, Inc.

INSTALLATION REQUIREMENTS

¹⁄₂
26 "
¹⁄₂
74 "
(189.2 cm)
¹⁄₈
62 "
(157.8 cm)
Torx ®† T25 screwdriver
Carpenter's level
Tape measure
Tape (masking or
painters)

Parts Supplied

Remove the parts from the trim kit package. Make sure all parts
are included.
IMPORTANT:
Do not use sharp objects to remove packaging materials to
avoid scratching surfaces.
The metal parts can be damaged if they are dropped.
A
B
C
D
E
F
Description (Quantity)
A. Top Trim Mount (1)
B. Top Grille (6) (shown
assembled)
C. Top Trim Notched Grille (1)
D. Top Plate (1)
E. Left-Hand Side Trim (1)
F. Gap Filler (1)
G. Right-Hand Side Trim (1)
H. Bottom Grille Assembly (1)
I. Rear spacer (2)
G
Stainless Steel White Part
Part Number Number
W10682840 W10682841
W10682846 W10682847
W10682843 W10682844
W10682876 W10682875
W10682850 W10682851
W10682856 W10682857
W10682853 W10682854
W10682833 W10682834
W10682858 W10682858
H
I
3