Table of Contents
Advertisement
uuWhen DrivinguAuto Idle Stop
Manual transmission models
Auto Idle Stop
To help maximise fuel economy, the engine automatically stops when the vehicle
comes to a stop, depending on environmental and vehicle operating conditions. The
indicator (green) comes on at this time. The engine then restarts once the vehicle is
about to move again, depending on environmental and vehicle conditions, and the
indicator (green) goes off.
2 The Engine Automatically Restarts When: P. 535
Auto Idle Stop
Indicator (Green)
532
If the driver's door is opened while the
indicator (green) is on, a buzzer sounds to
notify you that Auto Idle Stop function is in
operation.
A message associated with Auto Idle Stop
appears on the driver information interface.
2 Indicators P. 98
2 Customized Features P. 158, 413
1Auto Idle Stop
The 12-volt battery installed in this vehicle is
specifically designed for a model with Auto Idle Stop.
Using a 12-volt battery other than this specified type
may shorten the 12-volt battery life, and prevent
Auto Idle Stop from activating. If you need to replace
the 12-volt battery, make sure to select the specified
type. Ask a dealer for more details.
2 Specifications P. 770
The duration of the Auto Idle Stop operation:
•
Increases in the ECON mode, compared to when
the ECON mode is off, with climate control in use.
Advertisement
Table of Contents
Need help?
Do you have a question about the CR-V 2019 and is the answer not in the manual?
Questions and answers
How do I clear the garage door opener button of a code from a previous garage?
To clear the garage door opener code on a 2019 Honda CR-V:
1. Press and hold the two outside buttons on the HomeLink system for about 20 seconds until the red indicator blinks.
2. Release the buttons.
This erases any previously entered codes. If training a new button, proceed with the programming steps.
This answer is automatically generated
After starting with remote how to drive without stopping the car
After starting the 2019 Honda CR-V with the remote, you must do the following to drive without stopping the car:
1. Enter the vehicle with the keyless remote.
2. Press the brake pedal.
3. Press the ENGINE START/STOP button to turn the ignition fully on.
4. Shift the gear to (D) or (R) as needed.
This allows you to drive without stopping and restarting the engine.
This answer is automatically generated