Table of Contents
Advertisement
Adjusting the Seats
Front Seats
Allow sufficient
space.
Move back.
■
Adjusting the Seat Positions
■
Adjusting the front power seat
Horizontal
Position
Adjustment
Height
Adjustment
*
(Driver's seat
only)
* Not available on all models
Adjust the driver's seat as far back as possible
while allowing you to maintain full control of
the vehicle. You should be able to sit upright,
well back in the seat and be able to
adequately press the pedals without leaning
forward, and grip the steering wheel
comfortably. The passenger's seat should be
adjusted in a similar manner, so that it is as far
back from the front airbag in the dashboard
as possible.
*
Seat-back Angle
Adjustment
1Adjusting the Seats
WARNING
3
Sitting too close to a front airbag can result
in serious injury or death if the front
airbags inflate.
Always sit as far back from the front
airbags as possible while maintaining
control of the vehicle.
In addition to the seat adjustment, you can adjust the
steering wheel up and down, in and out. Allow at
least 25 cm between the centre of the steering wheel
and the chest.
Always make seat adjustments before driving.
Continued
249
Advertisement
Table of Contents
Need help?
Do you have a question about the CR-V 2019 and is the answer not in the manual?
Questions and answers
How do I clear the garage door opener button of a code from a previous garage?
To clear the garage door opener code on a 2019 Honda CR-V:
1. Press and hold the two outside buttons on the HomeLink system for about 20 seconds until the red indicator blinks.
2. Release the buttons.
This erases any previously entered codes. If training a new button, proceed with the programming steps.
This answer is automatically generated
After starting with remote how to drive without stopping the car
After starting the 2019 Honda CR-V with the remote, you must do the following to drive without stopping the car:
1. Enter the vehicle with the keyless remote.
2. Press the brake pedal.
3. Press the ENGINE START/STOP button to turn the ignition fully on.
4. Shift the gear to (D) or (R) as needed.
This allows you to drive without stopping and restarting the engine.
This answer is automatically generated