Installation Instructions - Sheet 2
2.2 Installation - Configuration
Install using LonWorks Network Manager Tool
4
If a
binding IQLs to LonMark devices
or b
LINCs version <3.23 straddle router
or c
other devices have address conflicts with IQ System devices
or d
LONROUTERs used on installed system
If one IQ System Lon device is installed, all must be installed.
a). When installing IQL in LonWorks tool, press
service button when requested.
1 3 +
L
L A N
O / S
S t r a t e g y
N I D
:
:
:
:
:
S e r i a l N o
b). The IQL network image can be obtained from
www.lonmark.org, or from www.pnet.trend-
controls.com.
c). Set up bindings if required (bind network
variables between IQL and LonMark devices).
5
Connect software tool for commissioning
if required
IqlTool2 (SET)
IqlTool2 runs within SETV5.1 (or later)
Lon adapter cable
supplied with LCI
LCI
6
Exercise I/O
If IqlTool2 available
LCI
IQL13+/xxx Installation Instructions TG200383 Issue 3/B 19/08/04
(continued)
SRV PIN
service button
RS232 cable
supplied with LCI
IQL
Lon
IqlTool2
(SET)
IQL
Lon
See LonWorks network management
tool manual. See IQ System LonWorks
Products
(TE200292).
Integrator must have LonWorks
engineering expertise.
Lonmark
device
IQL
LINC
Note that a PIN may be required to make
changes. If the PIN has been forgotten the
users should contact their supplier
(installers contact Technical Support) quoting the
generator number and neuron id (both from Address
module) whereupon a default PIN will be supplied.
This will only work for three attempts at entering the
PIN. After the default PIN is entered a new PIN
should be set up and remembered.
Use IqlTool2 to monitor inputs and exercise outputs
IqlTool2 Manual TE200185
Note that IqlTool2 may also be used for mapping the
Lon segment, resolving duplicate addresses on Lon,
water balancing (/WR2, /WR4, /WT2, /WT4 only),
identification via service button, associating with SDU-
LON (for other uses see later)
IQL13+/xxx
Engineering
Manual
LonWorks
System
Lon
IQL13+ Data Sheet
TA200205 for Lon
network variables (NVs)
IqlTool2 Manual
TE200185
LCI Installation
Instructions TG200429
SET Manual TE200147
2 - 3
Need help?
Do you have a question about the LonMark IQL13+ Series and is the answer not in the manual?
Questions and answers