Chapter 2 Installation and Wiring
Fitting nails
嵌合ツメ
[CPU Slot]
Connector
6F8C1590
16
Procedure for removing
(1) Turn off the power of GA932 module and external power
supplied to I/O modules.
(2) Push the fixing nails of the connector to release the lock,
remove the optical cable from the module.
(3) Loosen the mounting screw at the bottom of the module.
The lock of the fixing nails is released when sliding the slide lever
at the top of the module toward you. While sliding pull the top of
the module towards you and remove it.
Figure 2.3 GA932 Module removing
Check again before operation.
The Before turning on the power to operate the product, check
again that the switch setting, installation, and wiring are as
described in this operation manual.
[T3/T3H Basic Base Unit]
Slide lever
Sliding the slide lever toward you
<Top of the module>
Rail
Fitting nails
Slide direction
Slide lever