Sharp WH-236E Service Manual page 7

2.5. The shower assembly.
The joint the shower hose counterclockwise with the shower.
2.6. Installation the shower stand.
Ensure that the shower stand located in the level that the top part of the shower head is not
higher than the top part of the unit when hanging the shower head. (See in the picture)
The angle of shower head holder can adjust into 2 levels.
3. PIPING INSTALLATION
1. Connection point between the unit and the water volume knob and twist the shower hose by
hands until it tight. Do not use any tools during assembly because it may cause the damage to
plastic components.
2. Tighten the connection into the thread located at the bottom of the water volume knob.
Force gauge do not exceed 40 kgf.cm.
3. Connect water inlet pipe and water outlet pipe as shown in the picture.
Use pipe at least 15 cm. in length
Shower head
Joint
Shower hose
Fig. 12
Shower head
O-ring fi xer
Shower hose
Notifi cation in connecting the shower hose.
Connect to the shower head.
7
Connect to the unit.
Fig. 13
Water inlet
Filter
Water volume knob
O-ring
Main water valve
Fig. 14