Sharp WH-236E Service Manual page 6

2.2. Removing the unit cover.
Remove the screw underneath the unit.
Open the cover by lifting from the bottom.
2.3. Mounting the unit to the wall.
Drill two 6 millimeters holes in the wall with approximately 25 millimeters in depth.
Install wall anchors into the holes.
Screw the top wall anchors, leave screw length around 8-10 millimeters and hang the unit on the
screw then marked the position in order to drill another 2 holes at the bottom, drill the holes and
install the rest of wall anchors then fasten all of 4 screws.
2.4. Assemble the cover with the heater.
Assemble the cover from the bottom of the heater and push tight on the top of cover.
Tighten screws to attach the cover with the heater to the same position.
Screw
25 mm.
Fig. 11
Fig. 9
6
Fig. 8
Fig. 10