Cisco 350 Series Administration Manual page 682

24
STEP 4
460
• IPv6 Address Type—Select the supported IPv6 address type if IPv6 is used. The
options are:
- Link Local—The IPv6 address uniquely identifies hosts on a single network link. A
link local address has a prefix of FE80, is not routable, and can be used for
communication on the local network only. Only one link local address is supported.
If a link local address exists on the interface, this entry replaces the address in the
configuration.
- Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
• Link Local Interface—If the IPv6 address type is Link Local, select whether it is
received through a VLAN or ISATAP.
• IP Address—Enter the SNMP management station IP address.
• Community String—Enter the community name used to authenticate the management
station to the device.
• (Community Type) Basic—In this community type, there is no connection to any
group. You can only choose the community access level (Read Only, Read Write, or
SNMP Admin) and, optionally, further qualify it for a specific view. By default, it
applies to the entire MIB. If this is selected, enter the following fields:
- Access Mode—Select the access rights of the community. The options are:
Read Only—Management access is restricted to read-only. Changes cannot be made
to the community.
Read Write—Management access is read-write. Changes can be made to the device
configuration, but not to the community.
SNMP Admin—User has access to all device configuration options, as well as
permissions to modify the community. SNMP Admin is equivalent to Read Write
for all MIBs except for the SNMP MIBs. SNMP Admin is required for access to the
SNMP MIBs.
- View Name—Select an SNMP view (a collection of MIB subtrees to which access
is granted).
• (Community Type) Advanced—Select this type for a selected community.
- Group Name—Select an SNMP group that determines the access rights.
Click Apply. The SNMP Community is defined, and the Running Configuration is updated.
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
SNMP
Communities