Cisco 350 Series Administration Manual page 141

Administration: File Management
DHCP Auto Configuration/Image Update
STEP 3
STEP 4
STEP 5
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
• Backup Server Definition—Select whether the backup server will be configured By
IP address or By name.
If Server Definition is By Address:
• IP Version—Select whether an IPv4 or an IPv6 address is used.
• IPv6 Address Type—Select the IPv6 address type (if IPv6 is used). The options are:
- Link Local—The IPv6 address uniquely identifies hosts on a single network link. A
link local address has a prefix of FE80, is not routable, and can be used for
communication only on the local network. Only one link local address is supported.
If a link local address exists on the interface, this entry replaces the address in the
configuration.
- Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
• Link Local Interface—Select the link local interface (if IPv6 is used) from the list.
Enter the following optional information that is used if the DHCP server did not provide the
required information.
• Backup Server IP Address/Name—Enter either the backup server IP address or name.
• Backup Configuration File Name—Enter the backup configuration file name.
• Backup Indirect Image File Name—Enter the indirect image file name to be used.
a file that holds the path to the image.
This is
name is: indirect-cisco.scp. This file contains the path and name of the firmware image.
The following fields are displayed:
• Last Auto Configuration/Image Server IP Address—Address of the last backup
server.
• Last Auto Configuration File Name—Name of the last configuration file name.
Click Apply. The parameters are copied to the Running Configuration file.
An example of an indirect image file
7
115