Philips ColourChaser Touch Installation Manual page 7

4 Plug the included 5 m UTP patch cable into the
RJ-45 socket on the back of the controller (or
use another UTP patch cable with a maximum
length of 40 meter).
5 Place the controller on the bracket and slide it
down over the hooks.
6 Tighten the set screw a few turns to hold the
controller in place. Do not over tighten: stop as
soon as you feel light resistance!
Power supply
Install the power supply in a dry location within a 40 meter cable run of the controller.
RJ-45
1
2
Philips ColourChaser Touch Manual 7