Back Panel
Serial Port
USB Port
DC Power Jack
Connect the power cable to this power jack; see
page
8-4.
USB Port
The USB port is High-speed (v2.0). Using the USB cable, you can connect the base to a USB-
compliant device to facilitate USB communication to and from the terminal. USB
communication occurs through Microsoft ActiveSync (v.4.1 or higher).
Serial Port
The serial port supports serial communication between the terminal and another device. Note
that the connector is a DB9 Male connector, requiring a female connector on the serial cable.
The following four signals are supported:
•
Transmitted Data
•
Received Data
•
Request to Send
•
Clear to Send
Note: ActiveSync is not supported over the serial port.
Ethernet Port (eBase only)
Using an Ethernet cable, you can connect the eBase to an Ethernet-compliant device to facilitate Ethernet
communication to and from the terminal. This equipment is for indoor use only. The communication
wiring is limited to the inside of a building.
HomeBase
DC Power Jack
Serial Port
USB Port
Ethernet Port
Powering the Dolphin HomeBase Device
eBase
DC Power Jack
on
8-3