Autostart Function; Reset To Factory Settings; Data Backup; Data Import - EuroLite DMX OPERATOR 240 User Manual

7
Press the button FINE to perform the identify
function for the device.
8
After your settings, switch off the
programming mode. For this, keep the button
AUTO/DEL pressed and simultaneously
press the button PROGRAM.
Regarding RDM
RDM stands for "Remote Device
Management" and makes remote control of
devices connected to the DMX bus possible.
RDM is an extension of the DMX512 protocol.
RDM is especially useful when the device is
installed in a remote area.
RDM is integrated in DMX without influencing
the connections. RDM data is transmitted via
the standard XLR pins 1 and 2 and does not
require a new cable type. RDM-ready and
conventional DMX devices can be operated in
one DMX line. If DMX splitters are used, they
must support RDM.

Autostart Function

After switching on, the controller can always call
the last illumination scene. For this, follow the
steps below:
1
Keep the two buttons AUTO/DEL and
SCENE 8 pressed simultaneously and switch
on the controller. The display indicates "RUN
SAVE".
2
Use the button TAP/DISPLAY to select the
setting "Yes".
3
Keep the two buttons AUTO/DEL and
SCENE 8 pressed simultaneously to
memorize your setting.
4
By short actuation of the button BLACKOUT
the setting is not memorized and the
procedure is aborted.

Reset to Factory Settings

The controller can be reset to its factory settings.
1
Switch off the controller.
2
Keep the four buttons SCANNER 1,
PROGRAM, MUSIC BANK/COPY and
AUTO/DEL pressed simultaneously and
switch on the controller.
3
The display shortly indicates "Reset factory
Please wait Z." and then "OK" as soon as
the factory settings are loaded.

Data Backup

All settings of a light show, i.e. DMX settings,
illumination scenes and chases can be stored on
a USB memory device and recalled later. 12
memory banks on the buttons SCANNER 1-12
are available.
1
Connect a USB memory device to the
controller's USB port.
2
Keep the button AUTO/DEL pressed and
simultaneously press the button BANK UP.
The display indicates "Select Save File"
(select memory bank).
3
Select a memory bank with one of the
buttons SCANNER 1-16. The display
indicates e.g. "FILE:1" and a progress bar.
Each memory bank must be stored
separately. If the control LED of a SCANNER
button lights, this memory bank has been
stored on the USB memory device before.
The data will be stored in the folder "DMX
Operator 240" located on the root directory of
the USB memory device. A file with the
extension "PRO" will be created for each
memory bank. You should not make any
changes to the default folder. Otherwise the
controller cannot the reload the data later.
4
After completing the data backup, the display
shortly inserts "FILE SAVE OK".
Regarding USB memory devices
• This unit supports data carriers with the file
system FAT32 and with a capacity up to 32
GB.
• If a data carrier is not recognized at the first
try, turn the controller off and on again.

Data Import

1
Connect a USB memory device to the
controller's USB port.
The files to be imported must be stored in
the folder "DMX Operator 240"located on the
root directory of the USB memory device.
2
Keep the button AUTO/DEL pressed and
simultaneously press the button BANK
DOWN. The display indicates "Select Read
File" (select file with SCANNER button).
The control LED of a SCANNER button
lights, when data is available on the USB
memory device for this memory bank.
38/40 00081310.DOCX, Version 1.0