Setting NEO:6 mode
You can play back 2 channel sound over 6.1 channels when enjoying music or a movie.
This mode decodes 2 channel signals to a high precision digital matrix decoder.
for 6.1 channel sound.
•
•
REMOTE CONTROL
Press NEO:6 MODE button.
Each time you press this button, MUSIC ➝ CINEMA will be selected in turn.
•
MAIN UNIT
1
Press SURROUND button briefly to select "NEO:6" mode.
Each time you press this button, DPLIIx ➝ NEO:6 ➝ SFE ➝ STEREO will
•
be selected in turn.
2
Press SELECT(
Each time you press this button, MUSIC ➝ CINEMA will be selected in turn.
•
To set the height of the center sound image
If your TV (or screen) is installed high on a wall, you can raise the center
sound image of the front and center speakers to compensate.
1
Press SETUP/MENU button, and then press the ENTER button.
"SETUP MODE" appears on the display and goes into Setup Mode.
•
2
Press
button to select the "NEO:6 MODE", and then
press the ENTER button.
"CEN -- IMG : 2" appears on the display.
•
3
Press
...†
button to set the sound image you want.
You can set the sound image from 0 to 5.
•
This parameter adjusts the height of the center image through the front and
•
center speakers. "0" is the lowest while "5" is the highest.
To exit setup mode
Wait for about 5 seconds or press SETUP/MENU button.
•
"SETUP OFF" appears on the display and Setup Mode is exited.
NEO : 6 Mode
MUSIC : NEO:6 MUSIC mode is optimized for music playback
CINEMA : NEO:6 CINEMA mode is optimized for movie playback.
NEO:6 mode cannot be used with DTS and Dolby Digital multi channel signals.
•
Pro Logic works only for PCM audio signals with sampling frequencies of
•
32KHz, 44KHz or 48KHz.
,
) button.
ENG
33