Preparation Procedure - GE e-terrapowercom Installation Manual

3. Preparation Procedure

Apart from cables and connectors, modem's installation only requires a stripping tool and a 3 mm screw
driver.
Installation time may be less than 5 minutes.
Cables and connectors may be supplied along with the modem. If not, please refer to the recommendation
lists below:
Cables
AC Supply IEC320 power cord
DC Supply Two wires, 12 to 16 AWG (1.5 to 3 mm2)
Ethernet Shielded Twisted Pair, Category 5
BPL signal 50 Ohms Twisted Pair, 12 to 16 AWG (1.5 to 3 mm2)
Ex:
AlphaWire 2432C (16 AWG)
Belden 5200FE (16 AWG)
Belden 5120FL (14 AWG)
Connectors (modem side)
AC input IEC320-C7 connector
DC input Plug, 2 pins, 5mm pitch
Ethernet RJ-45
BPL signal Plug, 3 pins, 5 mm pitch
Serial Plug, 6 pins, 3,5 mm pitch
Proprietary – See Copyright Page 9 e-terrapowercom v2 Installation Manual