Husqvarna 326 E Workshop Manual page 9

1
8
Starter
Offl oad the spring tension.
Remove the screw and the washer.
Carefully remove the drive disc for the pres-
sure equalisation spring.
502 50 18-01
Lift off the pressure equalisation spring.
Carefully lift off the starter pulley so that the
tension in the return spring is not released.
Assembly
Model H327 P5
Clean the component parts and assemble in
the reverse order as set out for dismantling.
Offl oad the spring tension.
Lift up the starter cord on the starter pulley
and allow it to rotate clockwise. Slow the
rotation with your thumb.
Remove the screw and the washer.
Carefully remove the drive disc for the pres-
sure equalisation spring.
Carefully lift off the pressure equalisation
spring so that the starter pulley does not
fl y off . There is a risk that the tension in the
recoil spring is released.
!
WARNING!
Wear protective glasses.
The return spring lies tensioned
in the starter and can fl y out and
cause personal injury with careless
handling.
Carefully lift off the starter pulley so that the
tension in the return spring is not released.
Assembly
Model H327 P5
Clean component parts before assembling.
Replace the return spring/starter pulley and
starter cord, if necessary.
NOTE!
The return spring and starter pulley
are supplied pre-assembled and
are fi tted in the starter housing as a
single unit.
Exercise care when opening the
packaging so that the spring does
not fl y out.