Macro Clear - Silvercrest KH2150 Operating Instructions Manual

Note:
After the tenth button press, the macro is automatically saved.
To save the macro at an earlier point, press the button
(11).
7. Press the desired button sequence. With each button
press, the counter goes up by one: MACRO1 KEY? 03,
MACRO 1 KEY? 04 etc. After the tenth button press, the
macro is saved and SUCCESS appears in the LCD display (2).
Note:
Note the programmed macros in the table "Personal macros"
at the end of these operating instructions.
Playing back a saved macro
Note:
The remote control must remain pointed at the device.
MACRO
1. Press the
LCD display (2).
Note:
If no macro is saved under 1, for example, MACRO 1 VOID
appears in the LCD display (2).
2. Press the number button (13)
shows MACRO 1, for example. The infrared symbol (22)
blinks and the saved button sequence is sent.

MACRO CLEAR

Clearing a saved macro.
S
1. Hold the
in the LCD display (2).
2. Press the down arrow button (6) repeatedly until MACRO
SETUP appears in the LCD display (2).
3. Press the right arrow button (6). MACRO SET appears in
the LCD display (2).
4. Press the down arrow button (6). MACRO CLEAR appears
in the LCD display (2).
5. Press the right arrow button (6). MACRO KEY? appears
in the LCD display (2).
6. Press the number button (13)
appears in the LCD display (2).
7. Press the right arrow button (6). First PLEASE WAIT... then
SUCCESS appears in the LCD display (2).
button (11). MACRO KEY? appears in the
button (5) pressed until CODE-SETUP appears
1 2 3
, or . The LCD display (2)
1 2 3
, or . CONFIRM CLEAR
28
MACRO