Programming By Manual Code Input - Silvercrest KH 2155 Operating Manual

Repeat these operational steps for all devices that you
would like to control with the remote control.

Programming by manual code input

In this mode the remote control can be programmed by
direct input of a code number. Please extract the necessary
code number from the accompanying code list. In the event
that the new code is invalid the last valid programmed code
will be restored.
1. Hold down the SET button e for a little longer than
3 seconds.
2. In the LCD display q appears "CODE SETUP". Press
the OK button l. "BRAND SRCH" now appears in the
LCD display q. Press the  or  button h until "CODE
SET" is shown in the LCD display q. Then press the OK
button l.
3. In the LCD display q appears the last programmed
device and the code used.
4. Press the desired device button r (i.e. VCR). The target
device now blinks and waits for your confirmation.
5. With the OK button l confirm the selected device. Now
the first digit of the code blinks and waits for your code
input.
6. Enter the 3 digit device code with the number buttons
and confirm the entry with the OK button l.
7. If the entered code is valid for the selected device type
then the code will be saved. In the LCD display q appears
"SUCCESS" and then again "CODE SET". In the event
of failure the LCD display q shows "NOT FOUND" and
waits for a new code input. Then you repeat step 6.
8. For many combi-devices you must enter 2 codes from
the accompanying list, i.e. one for the TV section and
one for the DVD section. If the code of a combi-device
(i.e. TV-DVD) is shown in the list as "XXX XXX" then apply
the first 3 numbers for the device named first in the device
denomination (=TV), and the last 3 numbers for the device
named second (=DVD).
9. With the EXIT button j you can end the CODE SET
mode.
- 13 -