Compass Calibration - SYMA GYRO REMOTE CONTROL SERIES User Manual

①
2.Compass Calibration：
Before the first flight, the compass calibration is required. When the remote
control has connected to the drone, push the left joystick to the right bottom
corner and hold it, then press the One key return button located at the upper
right corner of the remote control (Figure 1). When the indicator lights flash
slowly, release the left joystick and hold the drone horizontally and rotate 360
degrees till the indicators of the drone turn to fast flashing(approx 4 circles)
(Figure 2), and rotate it 360 degrees till the indicators turn to long bright (approx
4 circles) (Figure 3), the calibration finished.
①
Note: 1.Never calibrate the compass in a strong magnetic field or near the bulk metal,
such as magnetite, parking lot and buildings with underground reinforced.
2.Never carry the ferromagnetic material, such as mobile phone, with you when
calibrating.
3.Take a compass calibration when the drone drifting or swinging around during
the flight.
3.Search satellite (indoor flight can't search satellite)
The rear lights of the drone begin as solid orange, and turn to blink green about
1 minute later when finish the satellite signal searching. After 5 seconds, the
blink green lights change to solid green, that indicates there are enough GPS
points recorded successfully, and the drone is able to fly off the ground with
GPS fix-piont function.
4.Turning on the drone
②
②
Method 1:Push the left joystick (throttle) to the highest
point and then back to the center,of the drone
the blades start rotating slowly.
-6-
③
③